Triconex AI3351库存备件
线路电抗器
编号：DC Amps AC Line Amps Hp IP00（开放式）线路电抗器线路电抗器AC输入接触器非再生再生类别。数量kW（Hp）类别。 此驱动额定值无交流输入接触器-必须在当地采购。驱动Cat。编号：DC Amps AC Line Amps Hp IP00（开放式）线路电抗器线路电抗器AC输入接触器非再生再生类别 隔离变压器-IP32，NEMA/UL 3R型独立，4…6%标称阻抗隔离变压器可用于具有特定类型交流电源配置或因交流线路干扰需要驱动保护的装置。三相初级三相次级kVA kW（Hp）电压230V次级460V次级575V次级类别号。
端子适配器套件
架D端子适配器套件以下机架D驱动器需要列出的端子适配器套件，以满足UL安装要求。三相一次三相二次kVA kW（Hp）电压230V二次460V二次575V二次分类号 不属于Rockwell Automation的商标是其各自公司的财产。出版物2364F-5.13 1999年6月更换套件说明RGU™ 隔离板更换内容本文档介绍了如何拆卸和更换再生直流母线电源装置（RGU）中的隔离板和负载电阻器。此工具包包含的内容使用下表，验证您已收到工具包中的相应项目。如果您收到了隔离板套件：如果您收到负载电阻器套件：注意：请参阅表a以验证您是否收到了适当的负载电阻器套件。
Line reactor
No.: DC Amps AC Line Amps Hp IP00 (open type) Line reactor Line reactor AC input contactor Non regenerative regeneration category. Quantity kW (Hp) category. This drive rating has no AC input contactor - must be purchased locally. Drive Cat. No.: DC Amps AC Line Amps Hp IP00 (open type) Line reactor Line reactor AC input contactor Non regenerative regenerative type isolation transformer IP32, NEMA/UL 3R type independent, 4... 6% nominal impedance isolation transformer can be used for devices with specific type of AC power supply configuration or requiring drive protection due to AC line interference. Three phase primary three-phase secondary kVA kW (Hp) voltage 230V secondary 460V secondary 575V secondary category number.
KIT-TERMINAL ADAPTER
Rack D Terminal Adapter Kit The following rack D drives require the listed terminal adapter kit to meet UL installation requirements. The three-phase primary three-phase secondary kVA kW (Hp) voltage 230V secondary 460V secondary 575V secondary classification number does not belong to the trademark of Rockwell Automation and is the property of their respective companies. Publication 2364F-5.13 June 1999 Replacement Kit Description RGU ™ Isolation board replacement content This document describes how to remove and replace the isolation board and load resistor in the regenerative DC bus power supply unit (RGU). Use the following table to verify that you have received the corresponding items in the toolkit. If you have received the isolation board kit: If you have received the load resistor kit: Note: Refer to Table a to verify that you have received the appropriate load resistor kit.
