DS200TBCAG1AAB机械设备卡件
机架安装
它使用VME C.1标准格式通过机架安装的背板与I/O和智能选件模块通信。支持的选项模块包括LAN接口模块、可编程协处理器、字母数字显示协处理器、用于IC660/661 I/O产品的总线控制器、通信模块、I/O链路接口以及所有IC697系列离散和模拟I/O模块。MEM保护a45722 Y R E B A T模块IC697CPX782标签44A726758–152R01串行端口3使用此插槽1中的模块仅在顶部远程编程器上关闭CPX 782正常运行EN-ON=正常，启用，保护前运行，输出启用运行，输出禁用停止键位置模块功能电池连接器在拔下旧电池之前安装新电池。USEIC697ACC701内存保护RS-485兼容96 MHz 32位中央处理单元P1 P2 P3串行端口2 RS-485兼容性工厂测试串行端口1 RS-232OK RUN EN CENTRAL PROCESSOR UNIT MEM PROTECT P1 P2 P3 MS-DOS、Windows、Windows 95和Windows NT是Microsoft Corporation的注册商标。
内存中央处理单元
96 MHz，32位，浮点，1 Mbyte内存中央处理单元GFK-1431F 2 PLC CPU 1999年11月系列90-70可编程控制器数据表手册GFK-0600F 20-2 a45677 IC66*I/O块编程器机架1机架0 P S C P U B T M G B C B R M P C M IC66*I/O总线（最大7500英尺（2285米））机架6机架7 B R M G B C B R M一米一米IC66*I/O总线（最大7500英尺（2285米））ps I/O终端（最后一个机架）从BTM到最后一个BRM的所有互连电缆的总长度最大为50英尺（15米）。所有机架必须处于相同的接地电位（最多8个机架）。注：图例CPU-选定CPU型号BRM-总线接收器模块，BEM711 BTM-总线发射器模块，BEM 713 GBC/NBC-总线控制器，BEM731/734 PCM-可编程协处理器模块，PCM711 PS-电源，PWR710/711/724/748并联或N B C或N B B C图1。PLC系统配置示例用户RAM存储器CPX782具有内置存储板，带有1Mbyte电池支持的CMOS RAM存储器，用于存储用户数据（程序、配置和寄存器数据）。用户闪存CPX782具有256K内置闪存，用于存储用户数据（程序、配置和寄存器数据）。
Rack installation
It uses VME C.1 standard format to communicate with I/O and intelligent option modules through rack mounted backplanes. Supported option modules include LAN interface modules, programmable coprocessors, alphanumeric display coprocessors, bus controllers for IC660/661 I/O products, communication modules, I/O link interfaces, and all IC697 series discrete and analog I/O modules. MEM protection a45722 Y R E B A T module IC697CPX782 label 44A726758 – 152R01 Serial port 3 Use the module in slot 1 to turn off CPX 782 only on the top remote programmer Normal operation EN-ON=normal, enable, run before protection, output enable operation, output disable stop key Position module function Battery connector Install a new battery before removing the old battery. USEIC697ACC701 memory protection RS-485 compatible 96 MHz 32-bit central processing unit P1 P2 P3 serial port 2 RS-485 compatible factory test serial port 1 RS-232OK RUN EN CENTRAL PROCEDURE UNIT MEM PROTECT P1 P2 P3 MS-DOS, Windows, Windows 95 and Windows NT are registered trademarks of Microsoft Corporation.
Memory central processing unit
96 MHz, 32-bit, floating point, 1 Mbyte memory central processing unit GFK-1431F 2 PLC CPU November 1999 Series 90-70 Programmable Controller Data Sheet Manual GFK-0600F 20-2 a45677 IC66 * I/O block programmer rack 1 rack 0 P S C P U B T M G B C B R M C M IC66 * I/O bus (maximum 7500 feet (2285 meters)) rack 6 rack 7 B R M G B C B R M 1 meter IC66 * I/O bus (maximum 7500 feet (2285 meters)) ps I/O terminal (the last rack) The total length of all interconnecting cables from the BTM to the last BRM is a maximum of 50 feet (15 meters). All racks must be at the same ground potential (up to 8 racks). Note: legend CPU selected CPU model BRM bus receiver module, BEM711 BTM bus transmitter module, BEM 713 GBC/NBC bus controller, BEM731/734 PCM programmable coprocessor module, PCM711 PS power supply, PWR710/711/724/748 parallel connection or N B C or N B B C Figure 1. Example of PLC system configuration User RAM memory CPX782 has a built-in memory board with 1Mbyte battery supported CMOS RAM memory for storing user data (program, configuration and register data). The user flash memory CPX782 has 256K built-in flash memory for storing user data (program, configuration, and register data).
