07ZE61(07PS60) GJV3074321R302模块
输出信号规格输出信号：
模拟输出4-20mA，0-1V，0-10V数字输出RS422A，RS485精度等级：±0.1%FS输出更新周期：模拟输出约0.1秒数字输出约1秒约0.5秒分辨率：约1/30000输出阻抗：电压输出约10Ω负载电阻：电流输出400Ω或更小电压输出50kΩ或更大■ 显示规格上窗：LED下窗：LCD（带背光）108×24点■ 一般规格额定电源电压：一般电源规格100-240VAC 24V电源规格24VAC/24VDC额定电源频率：一般规格50/60Hz 24V电源规范DC，50/60Hz最大功耗：一般电源规格无选件100VAC 10VA 240VAC 15VA有选件100V 15VA 240V 20VA 24V电源规格无选件24V 10VA 24V 5W有选件24V 15VA 24V 10W电源故障对策：根据EEPROM保持设置内容（传输次数小于一百万次）端子螺钉：M3.5绝缘电阻：一次端子和二次端子20MΩ 或更多（500VDC）一次端子和接地端子20MΩ 或更多（500VDC）二次端子和接地端子20MΩ 或以上（500VDC）耐受电压：一次端子和二次端子之间1500VAC（1分钟）一次端子与接地端子之间150VAC（2分钟），电源（24VAC/24VDC）
外壳：
耐火聚碳酸酯颜色：灰色或黑色安装：嵌入式面板安装外部尺寸：96（高）×96（宽）×127（深）（距面板表面的深度为120）重量：无选件约450克有选件约580克■ 安全标准CE认证：EN61326:1997+A1+A2+A3 EN61010-1:2001（过电压类别II，污染等级2）Ú由于EMC指令的测试条件，指示值或输出值（相当于最大±10%或最大±2mV，以较大者为准）发生变化。UL文件编号：E214646 UL:UL61010-1第2版c-UL:CAN/CSA C22.2编号61010-1-04■ 参考工作条件环境温度：23℃±2℃环境湿度：55%RH±5%（无冷凝）电源电压：一般电源规格100VAC±1%24V电源规格24VDC±1%电源频率：一般电源规范50/60Hz±0.5%24V电源规范直流安装方向：向前或向后±3°，
Output signal specification Output signal:
Analog output 4-20mA, 0-1V, 0-10V Digital output RS422A, RS485 Accuracy class: ± 0.1% FS Output update cycle: analog output about 0.1s Digital output about 1s Resolution: about 1/30000 Output impedance: voltage output about 10 Ω Load resistance: current output 400 Ω or less Voltage output 50k Ω or more Display specification Upper window: LED Lower window: LCD (with backlight) 108 × 24 points ■ General specification Rated power voltage: General power specification 100-240VAC 24V power specification 24VAC/24VDC Rated power frequency: General specification 50/60Hz 24V power specification DC, 50/60Hz maximum power consumption: general power specification without option 100VAC 10VA 240VAC 15VA optional 100V 15VA 240V 20VA 24V power specification without option 24V 10VA 24V 5W optional 24V 15VA 24V 10W power supply fault countermeasure: according to the EEPROM retention setting content (transmission times less than one million) Terminal screw: M3.5 Insulation resistance: primary and secondary terminals 20M Ω or more (500VDC) Primary and ground terminals 20M Ω or more (500VDC) 20M Ω or above (500VDC) withstand voltage between secondary terminal and grounding terminal: 1500VAC (1min) between primary terminal and secondary terminal, 150VAC (2min) between primary terminal and grounding terminal, power supply (24VAC/24VDC)
Housing:
Fire resistant polycarbonate color: gray or black Installation: embedded panel installation External dimension: 96 (height) × 96 wide × 127 (deep) (the depth from the panel surface is 120) Weight: about 450g without options, about 580g with options. ■ Safety standard CE certification: EN61326:1997+A1+A2+A3 EN61010-1:2001 (overvoltage category II, pollution level 2). Due to the test conditions of EMC directives, the indicated value or output value (equivalent to the maximum ± 10% or the maximum ± 2mV, whichever is greater) changes. UL Document No.: E214646 UL: UL61010-1 Version 2 c-UL: CAN/CSA C22.2 No. 61010-1-04 ■ Reference working condition Ambient temperature: 23 ℃± 2 ℃ Ambient humidity: 55% RH ± 5% (non condensing) Power supply voltage: general power supply specification 100VAC ± 1% 24V power supply specification 24VDC ± 1% Power supply frequency: general power supply specification 50/60Hz ± 0.5% 24V power supply specification DC installation direction: forward or backward ± 3 °,
