48990001-LY DSSA165工控模块备件
物理/环境规格桌面组件尺寸
：16.73英寸宽×10.0英寸深×（1U）1.72英寸高。尺寸不包括防滑自粘脚。机架安装组件尺寸：基本尺寸与桌面组件相同，但包括两个用于标准19英寸机架的1U机架安装支架。前面板连接器：有八个行业标准SFP收发器。未安装收发器的SFP插座包含EMI防尘塞。有一个RJ45以太网连接器和一个9针内螺纹D超小型RS232连接器。布线：每个安装的SPF收发器需要一根双工LC型光纤电缆或两根单工LC型光缆。单工电缆最适合级联集线器。双工电缆可用于所有其他互连。后面板连接器：后面板包含电源输入模块，该模块包括电源开/关开关、4A/250V保险丝和全球认可的IEC插座。电源要求：90至264VAC，47至440Hz，25W。电源和电源输入模块符合安全标准：UL、C-UL:UL 1950 TUV:EN69050 CE:EN55022、EN61000-4-2、3、4、5；EN61000-3-2保险丝：1A，250V，5 x 20 mm，快动，IEC 60127-2标准玻璃或同等温度：工作温度：0°至+65°C储存温度：-40°至+85°C湿度：工作：相对湿度20%至80%，非冷凝储存：相对湿度20%-80%，非冷凝MTBF：总安装x数量：2317.3641 MTBF（小时）：431524.76监管：GE Fanuc嵌入式系统已计划对进行测试，以满足以下标准：，适用时：欧盟（CE标志）EN55024 EN55022辐射发射A级EN55022传导发射A级EN 61000-4-2（ESD）EN61000-4-3（辐射抗扰度）EN6100-4-4（EFT）EN61000-4-5（浪涌）EN610000-4-6（传导RF）EN61000-4-8（工频磁场）美国FCC第15部分，A级加拿大ICES-003，A级安全：的设计符合以下适用的安全标准：UL60950 EN60950（LVD）商标所有注册商标均为其各自所有者的财产。
Physical/Environmental Specifications Desktop Component Dimensions
: 16.73 inches wide × 10.0 inches deep × (1U) 1.72 inches high. Dimensions do not include non slip self-adhesive feet. Dimensions of rack mounting components: The basic dimensions are the same as those of desktop components, but include two 1U rack mounting brackets for standard 19 inch racks. Front panel connector: There are eight industry standard SFP transceivers. SFP sockets without transceivers include EMI dust plugs. There is an RJ45 Ethernet connector and a 9-pin female D subminiature RS232 connector. Cabling: Each installed SPF transceiver requires one duplex LC optical cable or two simplex LC optical cables. Simplex cables are best suited for cascading hubs. Duplex cables can be used for all other interconnections. Rear panel connector: The rear panel contains a power input module, which includes a power on/off switch, 4A/250V fuse and a globally recognized IEC socket. Power requirements: 90 to 264VAC, 47 to 440Hz, 25W. The power supply and power input module comply with safety standards: UL, C-UL: UL 1950 TUV: EN69050 CE: EN55022, EN61000-4-2, 3, 4, 5; EN61000-3-2 fuse: 1A, 250V, 5 x 20 mm, quick acting, IEC 60127-2 standard glass or equivalent temperature: operating temperature: 0 ° to+65 ° C storage temperature: - 40 ° to+85 ° C humidity: operating: relative humidity 20% to 80%, non condensing storage: relative humidity 20% to 80%, non condensing MTBF: total installation x Quantity: 2317.3641 MTBF (hours): 431524.76 Supervision: GE Fanuc embedded system has planned to test to meet the following standards:, When applicable: European Union (CE mark) EN55024 EN55022 Radiated Emissions Level A EN55022 Conducted Emissions Level A EN 61000-4-2 (ESD) EN61000-4-3 (Radiated Immunity) EN6100-4-4 (EFT) EN61000-4-5 (Surge) EN610000-4-6 (Conducted RF) EN61000-4-8 (Power Frequency Magnetic Field) US FCC Part 15, Level A Canada ICES-003, Class A safety: The design of is in accordance with the following applicable safety standards: UL60950 EN60950 (LVD) trademark All registered trademarks are the property of their respective owners.
反射存储器网络
功能•与GE智能平台反射存储器网络产品一起使用•使用小型可插拔（SFP）收发器提供多达八个端口•集线器组件最多可级联256个节点•自动旁路光纤网络中有缺陷或断开连接的节点•可选择通过信号丢失或通过丢失同步模式•每个端口重新生成串行光信号，消除链路损耗并减少抖动•可配置用于长度达10 km的电缆•10BaseT以太网TCP/IP端口用于远程访问和控制•RS232端口用于本地访问和控制可选19英寸1U机架安装或台式机箱•内部通用电源•如果接收器未检测到是一个管理集线器，设计用于与GE智能平台系列反射式存储器实时网络产品一起运行。反射内存集线器可以在检测到信号丢失或有效同步模式丢失时自动绕过端口，从而允许网络中的其他节点保持运行。由于光学端口是用小型可插拔（SFP）收发器实现的，因此只需要填充所需的端口。 SFP收发器可以是多模（短距离）或单模（长距离）收发器的组合。此功能允许在小型网络中节省成本并优化系统。对于更大的网络，可以级联多个组件，允许最多256个节点的托管集线器阵列。每个端口重新生成串行光信号，消除了插入损耗和电缆衰减的问题。信号再生也减少了抖动。RS232端口使您能够通过简单的PC串行端口监视和控制反射式存储器网络。以太网端口功能允许您通过局域网（LAN）或Web浏览器远程监视和控制集线器。
Reflective memory network
Functions • Used with GE Intelligent Platform Reflective Storage Network Products • Up to eight ports are available using small form factor pluggable (SFP) transceivers • Hub components can cascade up to 256 nodes • Defective or disconnected nodes in the optical network are automatically bypassed • Synchronization mode can be selected through signal loss or through loss • Serial optical signals are regenerated for each port, Eliminate link loss and reduce jitter • Configurable for cables up to 10 km long • 10BaseT Ethernet TCP/IP port for remote access and control • RS232 port for local access and control Optional 19 inch 1U rack mount or desktop chassis • Internal universal power supply • If the receiver does not detect that it is a management hub, it is designed to operate with GE Intelligent Platform Series reflective memory real-time networking products. Reflective memory hubs can automatically bypass ports when they detect a loss of signal or a loss of effective synchronization mode, allowing other nodes in the network to remain operational. Since optical ports are implemented with small form factor pluggable (SFP) transceivers, only the required ports need to be populated. The SFP transceiver can be a combination of multi-mode (short range) or single-mode (long range) transceivers. This feature allows cost savings and system optimization in small networks. For larger networks, multiple components can be cascaded, allowing a managed hub array of up to 256 nodes. Each port regenerates the serial optical signal, eliminating the problems of insertion loss and cable attenuation. Signal regeneration also reduces jitter. The RS232 port enables you to monitor and control the reflective memory network through a simple PC serial port. The Ethernet port feature allows you to remotely monitor and control the hub through a local area network (LAN) or web browser.
