57360001-K PLC/DCS系统模块
注意事项
仅用于室内4X型外壳的平坦表面。要将电线连接到电源连接器，请使用AWG 28-12电缆，拧紧扭矩至少为0.5 Nm。概述仔细阅读安全注意事项。检查交货是否有运输损坏。如果发现损坏，请尽快通知供应商。请勿在具有高度爆炸危险的环境中使用操作面板。供应商不对修改、更改或重建的设备负责。仅使用根据供应商规范制造的零件和附件。在安装、使用或修理操作面板之前，请仔细阅读安装和操作说明。切勿让流体、金属屑或接线碎屑进入操作面板的任何开口。
这可能导致火灾或电击。只有合格人员才能操作操作面板。将操作面板存放在低于/高于本手册建议温度的地方可能会导致LCD显示液体凝结/变成同位素。LCD显示液体含有强烈的刺激物。如果皮肤接触，立即用大量水冲洗。如果眼睛接触，请睁开眼睛，用大量水冲洗，并就医。第2节安装过程中的安全注意事项3BSE043449R501 11本手册中的数字用于说明目的。由于与任何特定安装相关联的许多变量，
matters needing attention
For flat surfaces of indoor 4X enclosures only. To connect the wire to the power connector, use an AWG 28-12 cable with a tightening torque of at least 0.5 Nm. Overview Read the safety precautions carefully. Check the delivery for transport damage. If any damage is found, please notify the supplier as soon as possible. Do not use the operation panel in an environment with a high explosion hazard. The supplier is not responsible for the modified, changed or rebuilt equipment. Use only parts and accessories manufactured according to supplier specifications. Please read the installation and operation instructions carefully before installing, using or repairing the operation panel. Do not allow fluid, metal chips or wiring debris to enter any openings in the operator panel. This may cause fire or electric shock. Only qualified personnel can operate the operation panel.
Storing the operation panel below/above the temperature recommended in this manual may cause the LCD display liquid to condense/become isotopes. LCD shows that the liquid contains strong irritants. In case of skin contact, rinse immediately with plenty of water. In case of eye contact, open your eyes, rinse with plenty of water and seek medical advice. Section 2 Safety Precautions during Installation 3BSE043449R501 11 The numbers in this manual are for illustrative purposes. Because of the many variables associated with any particular installation,
