BASLER A402KC工业相机,A402KC中文说明
CPU可能产生致命故障包含DOIO函数的if逻辑阻止对智能模块的调用是反复转换运行和停止模式。存储包含对DOIO功能块调用的程序逻辑可能会导致CPU耗尽系统内存。当可编程逻辑控制器多次在运行和停止模式之间切换。存储硬件配置将导致释放系统内存，PLC将恢复正常运行。CPU可能产生致命故障在存储带有大配置在存储具有非常大容量的文件夹期间，CPU可能会产生致命故障配置如果将逻辑和配置存储在同时，
BASLER A402KC工业相机或通过从程序员处读取引用表数据的请求或HMI。有关详细信息，请参阅第3页的“存储大型配置”建议。从闪存读取损坏的数据记忆可能导致看门狗超时如果从闪存中读取损坏的数据，则PLC上的看门狗计时器可能会触发。这可以通过完成有效的闪存存储来纠正。CPU可能产生致命故障使用配置模块时HHP跟随门店前往耗尽用户内存的PLC当用户试图在存储到可编程逻辑控制器（PLC）后，使用HHP配置一个模块，该可编程逻辑控制器为用户排气记忆力固件更新失败通过清除M/T和a通电写入闪存用户按下清除键和M/T键后，固件升级可能会失败HHP在通电期间启动，然后执行写入闪存。循环通电PLC将使升级得以继续。
The CPU may generate a fatal fault
if logic containing a DOIO function
block call to a smart module is
repeatedly transitioned between
RUN and STOP modes.
Storing program logic that contains a call to a DOIO function block may cause
the CPU to run out of system memory. This can occur when the PLC
transitions between RUN and STOP modes several times.
Storing the hardware configuration will cause the system memory to be freed,
and the PLC will resume normal operation.
CPU may generate a Fatal Fault
during store of folders with large
configurations
The CPU may generate a fatal fault during a store of a folder with a very large
configuration. This may be made worse by storing logic and configuration at
the same time, or by read requests for reference table data from a programmer
or HMI during the store. See “Storing Large Configurations” on page 3 for
recommendations.
Reading corrupted data from flash
memory may cause a Watch Dog
Timeout
If corrupted data is read from flash memory, the Watch Dog Timer on the PLC
may be triggered. This can be corrected by completing a valid flash store.
The CPU may generate a fatal fault
when configuring a module with
the HHP following a store to the
PLC that exhausts user memory
The 90-30 PLC CPU may generate a fatal fault when the user attempts to
configure a module with the HHP after a store to the PLC that exhausts user
