HONEYWELL 51309512-175模块,51309512-175配置教程
构建自定义长度的输入/输出总线扩展电缆本节提供了创建自定义长度输入/输出总线扩展电缆所需的详细信息。两种定制电缆这两种类型是：点对点–其一端有一个阳连接器，另一端有一个阴连接器另一端的连接器。这些通常与IC693CBL300一起使用提供Y形接头。这种组合节省了点到点的时间电缆的建造速度比Y形电缆快得多。 Y形接头-其一端有一个公接头和两个接头（一个公接头和一个女性）在另一端。
HONEYWELL 51309512-175模块构建定制长度输入/输出总线扩展电缆所需的组件注：标准Y形电缆上使用的特殊双头Y形连接器不是作为单独的组件提供。项目描述电缆：仅限Belden 8107（无替代品）：计算机电缆，箔屏蔽整体编织，双绞线30伏/80摄氏度（176华氏度）24 AWG（0.22 mm2）镀锡铜，7 x 32绞线传播速度=70%标称阻抗=100Ω25针公接头：压接插头=Amp 207464-1；引脚=Amp 66506-9焊塞=Amp 747912-225针母连接器：压接插座=Amp 207463-2；引脚=Amp 66504-9焊接插座=Amp 747913-2连接器外壳：套件-Amp 745833-5：金属电镀塑料（铜上覆镍塑料）压接环-Amp 745508-1，开口环套圈
Building Custom Length I/O Bus Expansion Cables
This section provides details needed to create custom length I/O Bus Expansion cables.
Two Types of Custom Built Cables
The two types are:
Point-to-Point – these have a single male connector on one end and a single female
connector on the other end. These are usually used with the IC693CBL300 which
supplies the Wye connection. This combination saves time since a point-to-point
cable can be built much faster than a Wye cable.
Wye - these have a single male connector on one end and two connectors (one male
and one female) on the other end.
Components Needed to Build Custom Length I/O Bus Expansion Cables
Note: the special two-headed Wye connector used on the standard Wye cables is not
available as a separate component.
Item
Description
Cable:
Belden 8107 only (no substitutes):
Computer cable, overall braid over foil shield, twisted-pair
30 volt/80C (176F)
24 AWG (.22 mm2) tinned copper, 7 x 32 stranding
Velocity of propagation = 70%
Nominal impedance = 100Ω
25 Pin Male Connector:
Crimp Plug = Amp 207464-1; Pin = Amp 66506-9
Solder Plug = Amp 747912-2
25 Pin Female Connector:
Crimp Receptacle = Amp 207463-2; Pin = Amp 66504-9
Solder Receptacle = Amp 747913-2
Connector Shell:
Kit - Amp 745833-5:
Metal-plated plastic (plastic with nickel over copper)
Crimp ring - Amp 745508-1, split ring ferrule
