IS200TTURH1CFD通用电气模块,IS200TTURH1CFD配置手册
在VersaMax输入/输出模块和载波手册中，GFK-1504K：▪ 第2-38页的注释应添加“承运人不能接通电源或拔下插头”。
▪ 跳线操作说明应包括添加“通电时不能修改跳线位置”。快速入门指南安装前检查
仔细检查所有运输集装箱是否损坏。如果任何设备如有损坏，请立即通知送货服务。保存损坏的运输集装箱以供交付服务机构检查。拆包后设备，记录所有序列号。保存运输集装箱以及包装材料，以防需要运输或装运任何部件系统的。
IS200TTURH1CFD通用电气模块1.只需将NIU点击到位，即可将其安装在DIN导轨上。注：NIU和连接载体必须安装在同一节上35mm x 7.5mm DIN导轨。DIN导轨必须具有导电性（未上漆）适当饰面
接地。（有关信息，请参阅标题“模块安装”空间要求或模块方向，或者如果您正在安装NIU处于过度振动区域）。2、在NIU上安装电源。电源上的闩锁必须处于解锁位置。对齐接头和闩柱并按下电源模块向下，直到电源卡入到位。将锁闩转到锁定位置，以将电源固定到
Documentation Update
In the VersaMax I/O Modules and Carriers Manual, GFK-1504K:
▪ The note on page 2-38 should have the addition “Carriers cannot be
plugged together or unplugged with power applied”.
▪ The descriptions of the operation of jumpers should have the
addition “Jumper positions cannot be modified with power applied”.Quick Start Guide
Preinstallation Check
Carefully inspect all shipping containers for damage. If any equipment is
damaged, notify the delivery service immediately. Save the damaged
shipping container for inspection by the delivery service. After unpacking
the equipment, record all serial numbers. Save the shipping containers
and packing material in case it is necessary to transport or ship any part
of the system.
1. Install the NIU on the DIN Rail by simply clicking it into place.
Note: The NIU and connecting carriers
must be installed on the same section
of 35mm x 7.5mm DIN rail.
The DIN rail must have a conductive
(unpainted) finish for proper
grounding.(Refer to the heading Module Installation for information about
space requirements or module orientation, or if you are installing
the NIU in an area of excessive vibration).
2. Install the Power Supply on the NIU.
The latch on the power supply must be
in the unlocked position.
Align the connectors and the latch post
and press the power supply module
down until the two tabs on the bottom of
the power supply click into place.
