VE3008控制卡件,VE3008使用方法
IMHSS03模块使用一个NTHS03液压伺服终端装置来终止其输入/输出连接。DIP分流器和跳线选择电源（系统电源或外部电源功率）。IMHSS03模块有四个模拟输入，九个模拟输出，三个数字输入和一个数字输出终止于第n个03位终端装置。
快速参考附录C提供了NTHS03输入/输出终端分配、跳线和双工分流设置、电路板的快速参考布局和电缆连接。参见液压伺服有关更多信息，请参阅终端单元（NTHS03）说明。图C-1显示了NTHS03电路板布局。表C-1
VE3008控制卡件列出NTHS03跳线设置。表C-2列出了终端装置双分流设置。图C-2显示了终端分配和输入/输出信号极性。图C-3显示了终端装置电缆连接。IMHSS03模块可以使用NIDI01数字输入/输出终端模块来终止其输入/输出连接。完整IMHSS03功能需要两个带有NKAS02的NIDI01模块终端电缆。一个NIDI01模块可以终止IMHSS03模块，但仅提供IMHSS02功能。终端模块上的跳线配置输入/输出信号。IMHSS03模块有四个模拟输入、九个模拟输出、三个数字输入和一个终止的数字输出在NIDI01终端模块。
The IMHSS03 module uses an NTHS03 Hydraulic Servo Termination Unit to terminate its I/O connections. Dipshunts and
jumpers select the power source (system power or external
power) for certain inputs and outputs. The IMHSS03 module
has four analog inputs, nine analog outputs, three digital
inputs and one digital output that terminate at the NTHS03
termination unit.
QUICK REFERENCE
Appendix C serves as a quick reference of NTHS03 I/O terminal assignments, jumper and dipshunt settings, circuit board
layout and cable connections. Refer to the Hydraulic Servo
Termination Unit (NTHS03) instruction for more information.
Figure C-1 shows the NTHS03 circuit board layout. Table C-1
lists NTHS03 jumper settings. Table C-2 lists the terminationunit dipshunt settings. Figure C-2 shows terminal assignments and I/O signal polarity. Figure C-3 shows the termination unit cable connection.The IMHSS03 module can use an NIDI01 Digital I/O Termination Module to terminate its I/O connections. Full IMHSS03
functionality requires two NIDI01 modules with an NKAS02
termination cable. One NIDI01 module can terminate the
IMHSS03 module, but will only provide IMHSS02 functionality.
Jumpers on the termination module configure the I/O signals.
The IMHSS03 module has four analog inputs, nine analog outputs, three digital inputs and one digital output that terminate
at the NIDI01 termination module.
