NW-BM85C002模块,NW-BM85C002使用配置教程
双列直插式开关和跳线设置，以及工作LED状态。
表A-1至A-5列出了以下人员选择的操作选项：设置IMHSS03双列直插式开关。表A-6列出了操作通过设置跳线选择的选项。表A-7列出了IMHSS03LED状态。
IMHSS03双列直插式开关和跳线设置表A-2列出了解调器增益设置。表A-3列出了控制器增益设置。这些表中的增益值适用于功能代码为150的模块。对于增益值
NW-BM85C002模块使用功能55的模块，请参阅功能代码应用手册。使用函数启动解调器调谐代码55，将解调器增益（双列直插式开关S2）设置为2。到使用功能代码55启动控制器调谐，将控制增益（双列直插式开关S3）设置为1。附录B涵盖了IMHSS03校准程序，使用功能代码150，模拟控制回路调谐理论和控制器增益调节程序。完成本节中的步骤
附录确保涡轮机节流阀的准确定位阀门和最佳频率响应。完成在操作液压伺服模块（HSS）之前，请执行本附录中的步骤。
INTRODUCTION
Appendix A contains a quick reference guide of IMHSS03
dipswitch and jumper settings, and operating LED states.
Tables A-1 through A-5 list the operating options selected by
setting the IMHSS03 dipswitches. Table A-6 lists operating
options selected by setting jumpers. Table A-7 lists IMHSS03
LED states.
IMHSS03 DIPSWITCH AND JUMPER SETTINGS
Table A-2 lists demodulator gain settings. Table A-3 lists controller gain settings. The gain values in these tables apply to
modules configured with function code 150. For gain values of
modules using function 55, refer to the Function Code Application Manual. To start demodulator tuning using function
code 55, set the demodulator gain (dipswitch S2) to two. To
start controller tuning using function code 55, set the controller gain (dipswitch S3) to one.Appendix B covers the IMHSS03 calibration procedure using
function code 150, analog control loop tuning theory and the
controller gain tuning procedure. Completing the steps in this
appendix insures accurate positioning of the turbine throttle
valve and the best possible frequency response. Complete the
steps in this appendix before placing the hydraulic servo module (HSS) in operation.
