FBM215输出个性模块,FBM215中文PDF用户手册
执行预防性维护的人员应满足以下资格。
•维护人员应是合格的电气技术人员或工程师，了解测试设备的正确使用以及如何处理电子电路。
•维护人员应知道汽轮机停机以及启动和工厂操作程序。预防性维护计划
表7-1为IMHSS03液压伺服模块。下表列出了根据指定任务分组的先前维护任务维护间隔。表7-1中的一些任务是自解释的。需要进一步解释的任务说明如下包含在预防性维护程序中。
FBM215输出个性模块注：预防性维护计划仅适用于一般用途。您的申请可能需要特别注意。检查HSS模块和模块安装单元是否有灰尘。必要时使用防静电真空吸尘器进行清洁。3个月
检查与HSS模块及其终端装置或模块相关的所有信号、电源和接地连接。请参阅步骤。
检查HSS模块和相关的终端单元或模块，特别注意至电源触点和边缘连接器。必要时进行清洁。请参阅步骤。12个月校准LVDT和液压执行器。请参阅步骤。根据需要
完成此表中的所有任务。
Personnel performing preventive maintenance should meet the
following qualifications.
• Maintenance personnel should be qualified electrical technicians or engineers that know the proper use of test equipment and how to handle electronic circuitry.
• Maintenance personnel should know turbine shutdown
and start-up, and plant operating procedures.
PREVENTIVE MAINTENANCE SCHEDULE
Table 7-1 is the preventive maintenance schedule for the
IMHSS03 Hydraulic Servo Module. The table lists the preventive maintenance tasks in groups according to their specified
maintenance interval. Some tasks in Table 7-1 are self explanatory. Instruction for tasks that require further explanation are
covered under PREVENTIVE MAINTENANCE PROCEDURES.
NOTE: The preventive maintenance schedule is for general purposes only. Your application may require special attention.Check the HSS module and module mounting unit for dust. Clean as necessary using an antistatic vacuum.
3 months
Check all signal, power and ground connections associated with the HSS module and its termination unit or module. See procedure.
Inspect the HSS module and associated termination unit or module, giving particular attention
to power supply contacts and edge connectors. Clean as necessary. See procedure.
12 months
Calibrate the LVDT and hydraulic actuator. See procedure. As needed
Complete all tasks in this table.
