MEN 01A201S12/5880-0009串行链路模块,A201SR04说明书文档
功能代码55生成输入/输出模块错误报告。这些问题报告为报告类型12。功能代码55生成五种模块问题报告错误类型（请参阅表6-2）。
•错误类型1-无响应/错误类型。
•错误类型2-校准错误。
•错误类型3-通道故障/超出范围。
•错误类型9-输入故障。
•错误类型12-输出固定。
MEN 01A201S12/5880-0009串行链路模块问题报告分为两类：主要或致命错误和轻微或非致命错误。致命错误指示给定的操作模式将不起作用。致命错误生成错误类型为1、2或3的模块问题报告。非致命错误表示模块已发现错误，但将继续运行。非致命错误生成错误类型为9和9的模块问题报告12表6-2。功能代码55模块问题报告错误类型模块错误纠正措施1-无响应/类型错误任何输入/输出扩展器总线通信故障。任何命令或数据校验和失败。错误也将由FC 55输出N+9指示。检查输入/输出扩展器总线分流，
拆下IMHSS03并重新插入。If错误递归，更换IMHSS03。硬件或D/A错误。错误也将由FC 55输出N+8或N+6指示，分别地1、拆卸IMHSS03。插入模块。如果错误再次出现，请更换模块。2、可以通过运行隔离原因诊断。
Function code 55 generates I/O module error reports. These
problem reports are report type 12. Function code 55 generates five module problem report error types (refer to Table 6-2).
• Error type 1 - no response/wrong type.
• Error type 2 - calibration error.
• Error type 3 - channel failure/out of range.
• Error type 9 - input failure.
• Error type 12 - output fixed.
Problem reports are broken down into two categories: Major or
fatal errors, and minor or nonfatal errors. Fatal errors indicate
that the given mode of operation will not function. Fatal errors
generate module problem reports having error types one, twoor three. Nonfatal errors indicate that the module has discovered an error but will continue to function. Nonfatal errors
generate module problem reports having error types nine and
12.
Table 6-2. Function Code 55 Module Problem Report
Error Type Module Error Corrective Action
1 - No response/
wrong type
Any I/O expander bus communication failure.
Any command or data checksum failure. Error
will also be indicated by FC 55 output N+9.
Check I/O expander bus dipshunts,
remove IMHSS03 and reinsert. If error
recurs, replace IMHSS03.
Hardware or D/A error. Error will also be indicated by FC 55 output N+8 or N+6,
respectively.
1. Remove IMHSS03. Insert the module.
If the error recurs, replace the module.
2. Cause may be isolated by running
diagnostics.
