12P3162X212串行链路模块,12P3162X212使用数据
HSS模块使用易受静电放电影响的设备。遵循以下处理程序：
注意：始终使用Bailey的现场静态套件（零件号1948385_1-由两条腕带、接地线组件、鳄鱼夹、，和静态耗散工作面）。
该套件使技师和静电耗散工作面接地至同一接地点，以防止静电放电损坏模块。
1、使用静电屏蔽袋。保持模块处于静态状态屏蔽袋，直到您准备好将其安装到系统中。保存袋子以备将来使用。
12P3162X212串行链路模块2、打开前将袋子磨碎。在打开装有半导体组件的袋子之前，将其触摸到设备外壳或均衡电荷的接地。3、避免接触电路。通过边缘；避免接触电路。4、避免半导体部分连接。验证所有连接到模块的设备都正确使用前接地。
5、地面测试设备。6、使用防静电现场维修真空。清除灰尘如有必要，从模块中删除。
7、使用接地腕带。将腕带连接到电源输入面板上的适当接地插头。这个电源入口面板上的接地插头必须有效通过连接至接地电极系统交流安全接地。
8、请勿使用铅笔设置双列直插式开关。避免双列直插式开关触点的污染可能导致
The HSS module uses devices susceptible to electrostatic dis
charge. Follow these handling procedures:
NOTE: Always use Bailey's field static kit (part number 1948385_1 -
consisting of two wrist straps, ground cord assembly, alligator clip,
and static dissipative work surface) when working with the modules.
The kit grounds a technician and the static dissipative work surface
to the same ground point to prevent damage to the modules by elec
trostatic discharge.
1. Use Static Shielding Bag. Keep the modules in the static
shielding bag until you are ready to install them in the system.
Save the bag for future use.
2. Ground Bag Before Opening. Before opening a bag con
taining an assembly with semiconductors, touch it to the
equipment housing or a ground to equalize charges.
3. Avoid Touching Circuitry. Handle assemblies by the
edges; avoid touching the circuitry.
4. Avoid Partial Connection of Semiconductors. Verify
that all devices connected to the modules are properly
grounded before using them.
5. Ground Test Equipment.
6. Use an Antistatic Field Service Vacuum. Remove dust
from the module if necessary.
7. Use a Grounded Wrist Strap. Connect the wrist strap to
the appropriate grounding plug on the power entry panel. The
grounding plug on the power entry panel must be effectively
connected to the earth grounding electrode system through the
AC safety ground.
8. Do Not Use Lead Pencils to Set Dipswitches. To avoid
contamination of dipswitch contacts that can result in
