TRICONRX AI3351串行链路模块, AI3351说明书
安装称重传感器
以下说明适用于典型的安装布置。允许变更前提是它们符合第C.4节“安装要求”中的要求。
清洁基础和其他安装表面。将下部转接板安装到称重传感器上。
用扭矩扳手将螺钉（包括在交货中）拧紧至24 Nm（18 ft.-lb）。
将称重传感器和下部转接板安装到基础上，但不要完全拧紧螺钉。将上部转接板安装到称重传感器上。
TRICONRX AI3351串行链路模块用扭矩扳手将螺钉（包括在交货中）拧紧至24 Nm（18 ft.-lb）。
将轴承箱和辊安装到上转接板上，但不要完全拧紧螺钉。注意安全将轴承或其他相邻详图安装到转接板时，必须使用螺钉不得伸入称重传感器。称重传感器可能会因施加的力。
根据安装要求调整称重传感器。拧紧地脚螺钉。根据安装要求调整轧辊。拧紧上部转接板中的螺钉。
C、 7.1称重传感器电缆的布线电缆必须用夹具支撑并布线，以防止通过缆绳
C、 7.2连接称重传感器延长电缆
见第C.10节，电缆连接器安装说明，3BSE019064
C.7 Mounting the Load Cells
The instructions below apply to a typical mounting arrangement. Variations may be allowed,
provided that they comply with the requirements in Section C.4, Installation Requirements.
1. Clean the foundation and other mounting surfaces.
2. Fit the lower adapter plate to the load cell.
Tighten the screws (included in delivery) with a torque wrench to 24 Nm (18 ft.-lb).
3. Fit the load cell and the lower adapter plate to the foundation,
but do not fully tighten the screws.
4. Fit the upper adapter plate to the load cell.
Tighten the screws (included in delivery) with a torque wrench to 24 Nm (18 ft.-lb).
5. Fit the bearing housing and the roll to the upper adapter plate,
but do not fully tighten the screws.
CAUTION
When mounting bearings or other adjacent details to adapter plates, screws must
not protrude into the load cell. The load cell can be damaged by an excessive
applied force.
6. Adjust the load cells according to the installation requirements.
Tighten the foundation screws.
7. Adjust the roll according to the installation requirements.
Tighten the screws in the upper adapter plate.
C.7.1 Routing the Load Cell Cable
The cable must be supported with clamps and routed to prevent force shunting through the
cable.
C.7.2 Connecting the Load Cell Extension Cable
See Section C.10, Mounting Instruction, Cable Connector, 3BSE019064, Rev. A.
