PACIFIC SCIENTIFIC 6410-024-N-N-N电子模件
安装备选方案、计算力和计算缠绕增益
5.1水平安装在大多数情况下，水平安装是最明显的最简单的解决方案。因此，称重传感器应尽可能水平安装。
但是，如果机器设计需要倾斜称重传感器的安装或腹板路径不允许足够的水平力，见图，倾斜
允许安装，并且计算更复杂（见第C.5.2节，倾斜安装）。
PFTL 301E称重传感器测量水平力应用于其顶面。称重传感器可以测量
PACIFIC SCIENTIFIC 6410-024-N-N-N电子模件两个方向。垂直作用力不是测量且不影响水平测量水平力有一个来源；
腹板张力产生的力（皮重没有测量方向上的力分量）。查看原力图中的计算。
将总水平力FRtot除以2，得到每个称重传感器的所需容量。
请勿为过载目的而加大ABB称重传感器的尺寸
由于称重传感器具有足够的过载能力
Mounting Alternatives, Calculating Force and Calculating Wrap Gain
C.5.1 Horizontal Mounting
In most cases, horizontal mounting is the most obvious
and simplest solution. The load cell should thus be
mounted horizontally when possible.
However, should the machine design require inclined
mounting of the load cell or should the web path not give
a sufficient horizontal force, see figure, the inclined
mounting is permitted and the calculations are somewhat
more complex, (see Section C.5.2, Inclined Mounting).
The PFTL 301E load cell measures the horizontal forces
applied to its top surface. The load cell can measure in
both directions. The vertical applied forces are not
measured and do not influence the horizontal
measurement. There is one source of horizontal forces;
the force from the web tension (the tare weight has no
force component in measuring direction). See the force
calculations in the figure.
Divide the total horizontal force FRtot by two to get the
required capacity of each load cell.
Do not oversize an ABB load cell for overload purposes
as the load cell has sufficient overload capacity
