FSC CC12403系统卡件,CC12403使用指导
在正常操作条件下，您的系统不需要任何维护。然而我们建议您进行定期检查。可采取以下预防措施取决于系统运行的环境类型。
5.2预防性维护单位测量值称重传感器可防止称重传感器长时间接触腐蚀性元素。
检查固定螺钉，必要时重新拧紧。
检查称重传感器和转接板之间的间隙确保它们不会被污垢堵塞可能导致分路力进入称重传感器。
如有必要，用压缩空气清洁间隙。
FSC CC12403系统卡件张力电子设备检查电路板是否正确固定电缆或电线没有损坏。
检查所有端子螺钉和电缆密封套正确拧紧。
连接电缆检查称重传感器和张力电子装置
损坏在测量系统的工作寿命期间，可能会发生干扰其和过程这些干扰可能以多种不同的方式出现，故障原因可能很难找到。然而，性质相似的扰动可以组合在一起通常它们有相同或相似的错误来源。
本章中的故障跟踪说明将帮助您快速找到并纠正常见故障。
6.2安全说明
追踪故障时，请阅读并遵循第1章引言中给出的安全说明。
但是，如果更严格，应以当地法规为准。
Under normal operating conditions, your system does not require any maintenance. However,
we recommend you to perform regular checks. The following preventive measures may be
taken depending on the type of environment in which your system operates.
5.2 Preventive Maintenance
Unit Measures
Load cells Protect the load cells from prolonged contact with
corrosive elements.
Check the fixing screws and re-tighten if necessary.
Check the gaps between load cell and adapter plates
to ensure that they are not clogged with dirt, which
can cause a shunt force into the load cell.
Clean the gaps with compressed air if necessary.
Tension Electronics Check that the circuit boards are properly secured
and that cables or wires are not damaged.
Check that all terminal screws and cable glands
are properly tightened.
Connection cables Check that the connection cables between the
load cells and the tension electronics are not
damaged.During the working life of your measurement system, events may occur that disturb it and your
process. These disturbances may appear in many different ways and the reason for the fault can
be difficult to find. However, disturbances similar in character can be grouped together and
usually they have the same or similar sources of error.
The fault-tracing instructions in this chapter will help you to quickly find and correct the most
common faults.
6.2 Safety Instructions
