1SBP260011R1001数控系统模块,1SBP260011R1001使用指导
使用外部开/关开关（未提供）启动和关闭张力电子设备ABB）。正常维修期间，无需操作员采取任何行动。
检查主张力控制机械是否准备好正常运行。
通过将外部开/关开关设置到on位置，打开张力电子设备。
对于IP 65版本（NEMA 4），也将内部开关设置为“ON”。
检查：-显示屏点亮-“电源”指示灯点亮-“状态”指示灯亮起（绿灯）。红灯指示错误。通过将外部接通/断开开关设置到断开位置，关闭张力电子设备。
1SBP260011R1001数控系统模块,4.5正常运行测量设备应永久开启，以获得最佳测量结果。这允许称重传感器和电子设备在均匀的温度条件下工作。
测量设备设计用于连续测试显示的测量值示例：
所选单位[N]，称重传感器标称荷载100 kN，测量值987654 N。显示值：987600 N。
选定单位【kN】，称重传感器标称荷载100 kN，测量值987654 N。显示值：987.6 kN。
与设置小数功能一起显示的测量值示例：
选定单位【pli】，称重传感器标称荷载1 kN，测量值46.5987 pli。
设置小数=2显示值：46.60 pli。
选定单位【pli】，称重传感器标称荷载1 kN，测量值46.5987 pli。设置小数=0显示值：47 pli。
The tension electronics is started and shut down using an external ON/OFF switch (not supplied
by ABB). During normal service no action from the operator is required.
1. Check that the main tension control machinery is ready for normal run.
2. Switch on the tension electronics by setting the external ON/OFF switch to position ON.
For the IP 65-version (NEMA 4) also set the internal switch to “ON”.
3. Check that:
- the display is illuminated
- the “Power” indicator is lit
- the “Status” indicator is lit (green light). Red light indicates an error.Shut-down the tension electronics by setting the external ON/OFF switch to position OFF.
4.5 Normal Run
The measurement equipment should be permanently on to achieve best measuring result. This
allows the load cells and electronics to operate under even temperature conditions.
The measuring equipment is designed for continuous dutyExamples of measuring values displayed:
Example 1:
Selected unit [N], Load cell nominal load 100 kN, Measured value 987654 N.
Value presented on display: 987600 N.
Example 2:
Selected unit [kN], Load cell nominal load 100 kN, Measured value 987654 N.
Value presented on display: 987.6 kN.
Examples of measuring values displayed together with the Set Decimals function:
Example 1:
Selected unit [pli], Load cell nominal load 1 kN, Measured value 46.5987 pli.
