1C31166G02通讯模块,1C31166G02使用配置说明
选择主站号。
配置总线参数，设置网络波特率。从PROFIBUS设备库中，选择从设备并将其拖动到网络视图中，以将从属设备添加到配置中。
9、对于每个从机：a、 设置从站编号b、 设置从属模块类型c、 为从设备分配I/O地址d、 配置从属参数笔记
输入/输出地址确定从数据映射到CLX的位置数据表。您可以使用“文件”菜单下的“打印预览”功能确定所有从设备的每个输入/输出模块映射到CLX处理器中的输入和输出数据阵列。
1C31166G02通讯模块使用零调制解调器电缆将PROFIBUS配置工具连接至扫描仪提供，或通过配置RSLinx驱动程序。
当CLX PLC处于程序模式或PBIM块启用清除模式时非活动，右键单击CLX Master并从快捷菜单中选择Connect。笔记
连接到CLX扫描仪之前，请确保已完成
其初始化（扫描仪正面显示绿色OK LED）
CLX PLC处于程序模式或PBIM块清除模式启用处于非活动状态。
12、当您正在通信时，在扫描仪。
Select the Master Station number.
7.
Configure the bus parameters and set the network baud rate.
8.
From the PROFIBUS Device library, select and drag the slave into the Network view to
add the slave to the configuration.
9.
For each slave:
a. Set the slave station number
b. Set the slave module type
c. Assign I/O addresses to the slave
d. Configure the slave parameters
Note
The I/O addresses determine where the slave data maps into the CLX
data table. You can use the Print Preview feature under the File menu to
determine where each I/O module for all your slaves is mapped to in the
input and output data arrays in the CLX processor.
10. Connect the PROFIBUS Configuration Tool to the scanner using the null modem cable
supplied, or by configuring an RSLinx driver.
11. While the CLX PLC is in Program mode or PBIM Block with Clear mode enabled is
inactive, right-click on CLX Master and select Connect from the shortcut menu.
Note
Before connecting to the CLX scanner, make sure that it has completed
its initialization (green OK LED displays on the front of the scanner)
and the CLX PLC is in Program mode or PBIM Block with Clear mode
enabled is inactive.
12. One you are communicating, the COMM LED flashes at one-second intervals on the
scanner.
