GE IC670ALG310 电压源模拟输出模块
1.产 品 资 料 介 绍:
中文资料:
GE IC670ALG310 电压源模拟输出模块的产品特点包括:
- 具有8个模拟通道,可以输出电压范围从-10V到+10V,分辨率为14位。
- 用户可配置的缩放比例,支持8个通道的输出电压,范围从-10V到+10V,分辨率为14位。
- 输出超范围高达约10.25V。
- 可现场重新校准或重置为出厂校准,所有校准数据存储在闪存中。
- 具有报告低于/超出范围故障的功能。
- 在操作期间从总线接口接收工程单元输出数据(BIU),并根据其校准和配置的缩放参数来缩放该数据,然后将数据转换为-10V至+10V范围内的输出电压。
- 如果主机发送的工程单位值导致输出值约为模块最大值或最小值的50mV,它将超出/低于范围,并将设置一位报警位。
英文资料:
The product features of GE IC670ALG310 voltage source analog output module include:
It has 8 analog channels and can output voltage ranging from -10V to+10V, with a resolution of 14 bits.
User configurable scaling ratio, supporting 8 channels of output voltage, ranging from -10V to+10V, with a resolution of 14 bits.
The output exceeds the range by about 10.25V.
Can be recalibrated on-site or reset to factory calibration, and all calibration data is stored in flash memory.
It has the function of reporting faults below/beyond the range.
During operation, receive engineering unit output data (BIU) from the bus interface, scale the data according to its calibration and configured scaling parameters, and then convert the data into output voltage within the range of -10V to+10V.
If the engineering unit value sent by the host causes the output value to be approximately 50mV of the module's maximum or minimum value, it will exceed/fall below the range and an alarm bit will be set.
2.产 品 展 示
3.主 营 品 牌
4.产 品 展 示
ASML 4022.471.6850 Printed Circuit Board
ASML 4022.435.24401 Crystal Table Proces
SR3624-4991 | AMAT 0100-90095 | DSDI451 ABB |
SRF3736-4983-84-5-56BC-CU | AMAT 0100-76295 | DSDI452 ABB |
SR3632-2094-48B | AMAT 0100-35066 | 57160001-NF DSDO115 ABB |
SRF3643-4593-7-56C | AMAT 0100-35414 | 57160001-AK DSDO120 ABB |
STF3758-5150-61-56BC | AMAT 0100-76109 | 5716075-K DSDX451 ABB |
本篇文章出自瑞昌明盛自动化设备有限公司官网,转载请附上此链接:http://www.jiangxidcs.com